App-info

Mix at a rate of 32oz to the acre with water. The water is just the carrier. You need to know two things when figuring how much fertilizer you need to add.

How many gallons your spray tank is.
How many gpa your sprayer applies at.

Example.

If you have a 200 gallon sprayer that applies at 10 Gallons Per Acre you would cover 20 acres so you would add 5 gallons of Texas Pasture Plus to the tank with your water following the instructions below.

Incompatible Herbicides:
Herbicides with 2,4-D except Lv6 are NOT tank-mix compatible with 15-10-5 or our C & C. They can be applied separately. We recommend and offer DuraCor* or any non-2,4D herbicide will mix fine. Organic is compatible with all herbicides we know of. (always jar-test)

SHAKE WELL: Shake those jugs like a paint can (especially Organic) before measuring off or adding to water. Shake the Organic and C&C extra vigorously. Laying the jug on sides and top for a few minutes each prior to shaking helps a lot. Very important nutrients will settle that need to be resuspended to get maximum benefits.

Organic jugs will swell up over time, so open vent cap to release gasses as needed.

How to tank mix:
1. Fill Batch tank 1/3 to 1/2 full of clean water.
2. Mix in surfactant alone first, then add Texas Pasture Plus, and finally your herbicide.
3. Agitate well while filling with remaining water.
Mix without herbicide will remain viable in your tank for several days. Always agitate before each use. Mix with herbicide should be applied right after mixing. Then empty tank and rinse well right after application.